Bedding Procedure
The bedding procedure is an important step when installing the GT systems or new rotors and pads.
Correctly bedded pads form a transfer layer of material on the surface of the disc which improves overall "bite" and performance. Without proper "pre-bedding" that simulates the correct heat and torque loads seen in actual driving conditions, a pad’s true potential cannot be realized. This process will also ensure that the pads will produce a rotor finish with a consistent transfer layer which prevents "judder" from occurring.
The Brembo Bedding Memo should be followed when installing a new Brembo system or new discs and / or street pads.
For race friction and / or track use, please contact us for detailed information regarding the appropriate bedding procedure to follow.
Memorandum
To : Gran Turismo Brake System Customers
From: Brembo North America, High Performance Division
Re: Important Post-Installation Notes
NOTE: It is very important to follow proper brake bedding procedure following installation. This is necessary not only for optimum performance of the system,but also to avoid onset of judder (vibration felt through brake and steering). The discs are delivered with a thin zinc coating to prevent corrosion. Prior to beginning the bedding procedure, this plating must be removed from the braking surfaces by driving the car slowly (under 30mph) and performing very light brakeapplications in order to remove the plating without generating heat. With too much heat or pedal pressure, this plating can be deposited unevenly on the disc, and impregnated into the pad, further increasing the likelihood of judder development. Once a visual inspection of the braking surfaces confirms that the plating has been evenly removed, begin with the bedding procedure as specified below.
- Drive vehicle to a remote area and perform at least 30 brake applications of 3 second duration. Use light/medium deceleration with varying starting speeds. Leave at least ½ mile between each brake application
- The purpose of this procedure is to gradually increase the temperature in the components without thermal shock, and to mate the brake pad and disc friction surfaces
- After the repeated stops, drive the vehicle for several miles with little or no braking in order to adequately cool the components
- The system is now ready for normal use
NOTE: This entire procedure must be complete before driving the vehicle as normal. It is especially important that this process is completed before any extended same-speed driving is done (i.e. freeway travel). Failure to follow these instructions greatly increases the likelihood of judder development
NOTE: After installation or bleeding of the brake system, flush any brake fluid from around the bleed screws, etc, using soapy water. Over time, brake fluid trapped in these areas may cause paint damage. Additionally, do not use acidicwheel cleaners when washing your vehicle, as they can cause damage to the caliper finish and aluminum disc mounting bells, as well as to the wheels themselves. Use only soap and water when cleaning wheels or braking components.
This document and any accompanying attachments are intended only for use by the addressee(s) named herein and may contain legally privileged and/or confidential information. If you are not the intended recipient of this document, you are hereby notified that any dissemination, distribution or copying of this document and any accompanying pages or attachments thereto, are strictly prohibited. If you have received this document in error, please immediately notify Brembo by telephone and permanently destroy the original and any copy of this document, and its accompanying pages and attachments. Thank you.
Rev-BNA0701